Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CURTAIN SHIELD AIRBAG ASSEMBLY (for CrewMax)

CURTAIN SHIELD AIRBAG ASSEMBLY (for CrewMax) > INSTALLATION

for Preparation Click here



1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY


  1. Install the curtain shield airbag with the 10 bolts.


    B169088

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }

    NOTICE:
    Do not twist the curtain shield airbag when installing it.

  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



2. INSTALL ROOF HEADLINING ASSEMBLY
  1. Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY" (for CrewMax) (Click here)



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).



4. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).