Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CENTER AIRBAG SENSOR ASSEMBLY (for Floor Shift Type)

CENTER AIRBAG SENSOR ASSEMBLY (for Floor Shift Type) > INSTALLATION

for Preparation Click here



1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY


    B166503
  1. Check that the ignition switch is OFF.

  1. Check that the cable is disconnected from the battery negative (-) terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  1. Install the airbag sensor with the 3 bolts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    NOTICE:
    1. If the center airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
    2. When installing the center airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

  1. Check that there is no looseness in the installation parts of the center airbag sensor.

  1. Connect the holder (with connectors).

  1. Check that the waterproof sheet is properly set.



2. INSTALL FRONT CONSOLE BOX


    B161746
  1. Install the front console box with the 6 screws and 2 clips.



3. INSTALL REAR CONSOLE BOX ASSEMBLY


    B161745
  1. Install the rear console box with the 2 screws and 4 bolts.



4. INSTALL CONSOLE BOX CARPET


5. INSTALL REAR CONSOLE END PANEL SUB-ASSEMBLY


    B161744
  1. except Regular Cab:
    Connect the connector.

  1. Attach the 7 clips to install the end panel.



6. INSTALL UPPER CONSOLE REAR PANEL SUB-ASSEMBLY
  1. w/ Trailer Towing System:
    Connect the connector.

  1. Attach the 6 clips to install the console panel.



  1. Install the clip.


    B171298



7. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


    B161742
  1. Attach the 12 clips to install the console panel.



8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    B167312
  1. Install the shift lever knob and twist it in the direction indicated by the arrow.



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).



10. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).