Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CENTER AIRBAG SENSOR ASSEMBLY (for Floor Shift Type)

CENTER AIRBAG SENSOR ASSEMBLY (for Floor Shift Type) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
  1. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal
  2. Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    B161741
  1. Twist the shift lever knob in the direction indicated by the arrow and remove it.



3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    B161742
  1. Detach the 12 clips and remove the console panel.



4. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY
  1. Remove the clip.

  1. Detach the 6 clips and remove the console panel.



  1. w/Trailer Towing System:
    Disconnect the connector


    B171298



5. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY


    B161744
  1. Using a moulding remover, detach the 7 clips and remove the end panel.

  1. except Regular Cab:
    Disconnect the connector.



6. REMOVE CONSOLE BOX CARPET


7. REMOVE REAR CONSOLE BOX ASSEMBLY


    B161745
  1. Remove the 2 screws.

  1. Remove the 4 bolts and rear console box.



8. REMOVE FRONT CONSOLE BOX


    B161746
  1. Remove the 2 clips.

  1. Remove the 6 screws and front console box.



9. REMOVE CENTER AIRBAG SENSOR ASSEMBLY


    B166503
  1. Disconnect the holder (with connectors).

  1. Remove the 3 bolts and airbag sensor.