SIDE AIRBAG SENSOR (for Regular Cab) > INSTALLATION |
| 1. INSTALL FRONT SIDE AIRBAG SENSOR |
![]() |
Check that the ignition switch is OFF.
Check that the cable is disconnected from the battery negative (-) terminal.
Install the door airbag sensor with the screw.
Check that there is no looseness in the installation parts of the side airbag sensor.
Connect the connector.
| 2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for Front Side) |
![]() |
Connect the 2 cables to the inside handle.
Attach the inside handle's knob to the door trim board.
Attach the 10 clips to install the door trim board.
![]() |
Install the inside handle and door trim board to the door trim panel with the screw.
Install the door trim board to the door panel with the screw.
Attach the clip.
| 3. INSTALL COURTESY LIGHT ASSEMBLY (for Front Side) |
![]() |
Attach the claw to install the courtesy light.
Connect the connector.
| 4. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH (for Front Side) |
![]() |
Attach the 3 clips to install the front lower door frame bracket garnish.
| 5. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (for Front Side) |
![]() |
Install the plate and regulator handle with the snap ring.
| 6. INSTALL FRONT ARMREST BASE PANEL UPPER LH (for Front Side) |
![]() |
Connect the connectors.
Attach the 2 clips to install the front upper armrest base panel.
| 7. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH (for Front Side) |
![]() |
Attach the 4 claws to install the bezel plug.
| 8. INSTALL REAR SIDE AIRBAG SENSOR |
![]() |
Check that the ignition switch is OFF.
Check that the cable is disconnected from the battery negative (-) terminal.
Install the side airbag sensor with the bolt.
Check that there is no looseness in the installation parts of the side airbag sensor.
Connect the connector.
| 9. INSTALL FRONT DOOR SCUFF PLATE LH (for Rear Side) |
![]() |
Attach the 6 claws and 3 clips to install the scuff plate.
| 10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 11. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).