Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CURTAIN SHIELD AIRBAG CUTOFF SWITCH

CURTAIN SHIELD AIRBAG CUTOFF SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
  1. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT DOOR SCUFF PLATE LH (for Regular Cab)


B165843
  1. Detach the 6 claws and 3 clips, and remove the scuff plate.



3. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab)


B165841
  1. Detach the 6 claws and 3 clips, and remove the scuff plate.



4. REMOVE COWL SIDE TRIM BOARD LH


B165704
  1. Remove the clip.

  1. Detach the 2 clips and remove the cowl side trim board.



5. REMOVE INSTRUMENT SIDE PANEL LH


    B160590
  1. Using a moulding remover, detach the 6 claws and remove the side panel.



6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B160593
  1. Remove the bolt.

  1. Remove the 3 screws.

  1. Detach the 3 claws and remove the finish panel.



7. REMOVE CURTAIN SHIELD AIRBAG CUTOFF SWITCH


    B166515
  1. Disconnect the connector.

  1. Detach the 2 claws and remove the switch.