Home › ENGINE ยท 2UZ-FE › EMISSION CONTROL › AIR PUMP (for Bank 2)

AIR PUMP (for Bank 2) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE THROTTLE BODY COVER SUB-ASSEMBLY


    A153486
  1. Remove the 2 nuts and throttle body cover.



3. REMOVE AIR CLEANER HOSE ASSEMBLY


    A153487
  1. Disconnect the vacuum hose and No. 2 ventilation hose.

  1. Loosen the 2 hose clamps.

  1. Remove the air cleaner hose.



4. REMOVE FRONT FENDER LINER RH


    A160255
  1. Remove the 9 clips and fender liner.



5. REMOVE NO. 2 AIR INJECTION SYSTEM HOSE


    A153461
  1. Using a clip remover, remove the 2 clips.

  1. Fold back the fender apron seal.



    A153497
  1. Disconnect the air pump connector.

  1. Disconnect the 2 clamps.



    A158132
  1. Remove the air injection system hose.



6. REMOVE AIR PUMP ASSEMBLY


    A153499
  1. Remove the bolt, 2 nuts and air pump.