Home › BODY ELECTRICAL › LIGHTING › IGNITION KEY CYLINDER LIGHT

IGNITION KEY CYLINDER LIGHT > INSTALLATION

for Preparation Click here



1. INSTALL IGNITION KEY CYLINDER LIGHT


    E145067E01
  1. Connect the connector.

  1. Attach the 2 claws to install the key cylinder light.

  1. Connect the unlock warning switch connector.



2. INSTALL UPPER STEERING COLUMN COVER


    E146420
  1. Attach the 4 clips to install the upper steering column cover onto the instrument panel cluster finish panel.

  1. Attach the claw to install the upper steering column cover.



3. INSTALL LOWER STEERING COLUMN COVER


    E146419
  1. Attach the 2 claws to install the lower steering column cover.

    NOTICE:
    Do not damage the tilt and telescopic switch.

  1. Using a screwdriver, while turning the steering wheel to the right and left, install the 2 screws and lower steering column cover.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).