AIR FUEL RATIO SENSOR > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE PROPELLER SHAFT HEAT INSULATOR (for 4WD) |
![]() |
Remove the 2 bolts and heat insulator.
| 3. REMOVE FRONT PROPELLER SHAFT ASSEMBLY (for 4WD) |
![]() |
for Front Differential Side:
Place matchmarks on the differential and propeller shaft flange.
Remove the 4 nuts, 4 washers and disconnect the propeller shaft from the differential.
![]() |
for Transfer Side:
Place matchmarks on the transfer and propeller shaft flanges.
Remove the 4 nuts and 4 washers.
Remove the propeller shaft from the transfer flange.
| 4. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY (for Regular Cab Standard Deck) |
Disconnect the air fuel ratio sensor connector.
Disconnect the heated oxygen sensor connector.
Remove the 2 bolts from the front No. 3 exhaust manifold.
Remove the 3 nuts and exhaust pipe.
| 5. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY |
Disconnect the air fuel ratio sensor connector.
Disconnect the heated oxygen sensor connector.
Remove the 2 bolts and 2 nuts from the center exhaust pipe.
Remove the 3 nuts and exhaust pipe.
| 6. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
Disconnect the air fuel ratio sensor connector.
Disconnect the heated oxygen sensor connector and 2 clamps.
Remove the 2 bolts from the center exhaust pipe.
Remove the 3 nuts and exhaust pipe.
| 7. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) |
![]() |
Using SST, remove the sensor.
| 8. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) |
![]() |
Using SST, remove the sensor.