Home › ENGINE ยท 2UZ-FE › ENGINE CONTROL SYSTEM › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > REMOVAL

for Preparation Click here


CAUTION:
  1. The procedures should be performed by at least 2 people.
  2. Wear protective gloves when removing the exhaust pipe.
  3. The exhaust pipe is extremely hot immediately after the engine has stopped.
  4. Confirm that the exhaust pipe has cooled down before removing it.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE PROPELLER SHAFT HEAT INSULATOR (for 4WD)


    A158903
  1. Remove the 2 bolts and heat insulator.



3. REMOVE FRONT PROPELLER SHAFT ASSEMBLY (for 4WD)


C158457E01
  1. for Front Differential Side:

    1. Place matchmarks on the differential and propeller shaft flange.

    2. Remove the 4 nuts, 4 washers and disconnect the propeller shaft from the differential.

      NOTICE:
      Use a rope to suspend the front edge of the propeller shaft.



    C158456E02
  1. for Transfer Side:

    1. Place matchmarks on the transfer and propeller shaft flanges.

    2. Remove the 4 nuts and 4 washers.

  1. Remove the propeller shaft from the transfer flange.



4. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY (for Regular Cab Standard Deck)
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the heated oxygen sensor connector.

  1. Remove the 2 bolts from the front No. 3 exhaust manifold.

  1. Remove the 3 nuts and exhaust pipe.



5. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the heated oxygen sensor connector.

  1. Remove the 2 bolts and 2 nuts from the center exhaust pipe.

  1. Remove the 3 nuts and exhaust pipe.



6. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the heated oxygen sensor connector and 2 clamps.

  1. Remove the 2 bolts from the center exhaust pipe.

  1. Remove the 3 nuts and exhaust pipe.



7. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


    A155873E02
  1. Using SST, remove the sensor.

    SST
    09224-00010  



8. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    A155869E02
  1. Using SST, remove the sensor.

    SST
    09224-00010