Home › ENGINE ยท 2UZ-FE › EMISSION CONTROL › AIR SWITCHING VALVE (for Bank 2)

AIR SWITCHING VALVE (for Bank 2) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE FRONT FENDER APRON SEAL RH


    A159335
  1. Remove the 5 clips and fender apron seal.



3. DISCONNECT NO. 1 WATER BY-PASS PIPE


    A159337
  1. Remove the 2 bolts and disconnect the water by-pass pipe.

    NOTICE:
    Do not disconnect the hoses. If it is necessary to disconnect the hoses, first drain the engine coolant.



4. DISCONNECT NO. 2 AIR INJECTION SYSTEM HOSE
  1. Disconnect the air injection system hose from the air switching valve.



5. REMOVE NO. 2 AIR TUBE


A153510
  1. Disconnect the air pump connector.

  1. Disconnect the wire harness clamp.



    A153512
  1. Remove the 4 nuts, No. 2 air tube and 2 gaskets.

    NOTICE:
    Be careful not to damage the installation surface of the gaskets.



6. REMOVE AIR SWITCHING VALVE ASSEMBLY


A153513E01
  1. Remove the 3 nuts and air switching valve.

    NOTICE:
    Do not hold the bracket of the air switching valve.