Home › BODY › WINDSHIELD / WINDOWGLASS › WINDSHIELD DEICER SYSTEM

WINDSHIELD DEICER SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the windshield deicer system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK LIN COMMUNICATION SYSTEM
    1. Check if the LIN communication system is functioning normally (Click here).
      Result 
      Result
      Proceed to
      LIN communication system is normal
      A
      LIN communication system is not normal
      B



    B.
    Go to LIN COMMUNICATION SYSTEM (Click here)
    A


    4.PROBLEM SYMPTOMS TABLE
    1. Refer to the problem symptoms table (Click here).
      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B



    B.
    Go to step 6
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here).

    2. DATA LIST / ACTIVE TEST (Click here).

    3. Operation Check (Click here).


    NEXT


    6.REPAIR OR REPLACE

      NEXT


      7.CONFIRMATION TEST

        NEXT

        END