A/F SENSOR HEATER RELAY > ON-VEHICLE INSPECTION |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE INTEGRATION RELAY (UNIT E) |
Remove the engine room relay block cover.
![]() |
Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room relay block.
Disconnect the 3 connectors.
| 3. INSPECT INTEGRATION RELAY (A/F SENSOR HEATER RELAY) |

Measure the resistance of the A/F fuse.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A/F fuse | Always | Below 1 Ω |
![]() |
Measure the resistance of the A/F relay circuit.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1C-1 - 1A-4 | When battery voltage is not applied to terminals 1A-2 and 1A-3 | 10 kΩ or higher |
| When battery voltage is applied to terminals 1A-2 and 1A-3 | Below 1 Ω |
| 4. INSTALL INTEGRATION RELAY (UNIT E) |
Connect the 3 connectors.
Install the integration relay to the engine room relay block.
Install the engine room relay block cover.
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |