Home › ENGINE · 1GR-FE › STARTING › ACC CUT RELAY

ACC CUT RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE ACC CUT RELAY
  1. Remove the clip.

  1. Detach the 2 clips and remove the cowl side trim board RH.

  1. Remove the relay.



3. INSPECT ACC CUT RELAY


    A087121E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    When battery voltage is not applied to terminals 1 and 2
    Below 1 Ω
    When battery voltage is applied to terminals 1 and 2
    10 kΩ or higher

    If the result is not as specified, replace the relay.



4. INSTALL ACC CUT RELAY
  1. Install the relay.

  1. Attach the 2 clips to install the cowl side trim board RH.

  1. Install the clip.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).