FRONT DOOR LOCK (for Double Cab) > INSTALLATION |
| 1. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH |
![]() |
Install the front door inside locking cable.
![]() |
Attach the 3 claws.
| 2. INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH |
![]() |
Install the front door lock remote control cable.
| 3. INSTALL FRONT DOOR LOCK ASSEMBLY LH |
Apply MP grease to the sliding and rotating areas of the door lock.
Install a new door lock wire harness packing to the door lock.
![]() |
Using a T30 ''TORX'' wrench, install the door lock with the 3 screws.
Connect the door lock connector.
| 4. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH |
![]() |
Insert the door glass into the door panel along the glass run as indicated by the arrows in the illustration.
![]() |
Install the door glass to the window regulator with the 2 bolts.
| 5. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH |
![]() |
Install the frame with the 2 bolts.
| 6. INSTALL FRONT DOOR SERVICE HOLE COVER LH |
Install the front door service hole cover to the door panel.
Connect the connector.
| 7. INSTALL FRONT NO. 1 DOOR TRIM BRACKET |
![]() |
Install the bracket with the 2 screws.
| 8. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH |
![]() |
Connect the 2 cables to the inside handle.
Connect the connector.
Attach the inside handle's knob to the door trim board.
![]() |
Attach the 9 clips to install the door trim board.
Install the inside handle and door trim board to the door trim panel with the screw.
Install the door trim board to the door panel with the screw.
Install the clip.
| 9. INSTALL FRONT DOOR ARMREST COVER LH |
| 10. INSTALL COURTESY LIGHT ASSEMBLY |
![]() |
for Double Cab, for CrewMax:
Connect the connector.
Attach the claw of the courtesy light to the front door trim.
![]() |
for Regular Cab:
Connect the connector.
Attach the claw of the courtesy light to the front door trim.
| 11. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH |
![]() |
Attach the 3 clips to install the front door lower frame bracket garnish.
| 12. INSTALL FRONT ARMREST UPPER BASE PANEL LH |
![]() |
Connect the connectors.
Attach the 2 clips to install the front armrest upper base panel.
| 13. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH |
![]() |
Attach the 4 claws to install the bezel plug.
| 14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |