Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SIDE AIRBAG SENSOR (for CrewMax)

SIDE AIRBAG SENSOR (for CrewMax) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
  1. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH (for Front Side)


    B165648E02
  1. Using a screwdriver, detach the 4 claws and remove the inside handle bezel.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE FRONT UPPER ARMREST BASE PANEL LH (for Front Side)


    B166211
  1. Using a screwdriver, detach the 2 clips and front armrest upper base panel.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connectors.



4. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH (for Front Side)


    B168274E01
  1. Detach the 3 clips and remove the door lower frame bracket garnish.



5. REMOVE COURTESY LIGHT ASSEMBLY (for Front Side)


    B165655
  1. Detach the claw and remove the courtesy light from the door trim board.

  1. Disconnect the connector.



6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for Front Side)


    B166215E01
  1. Remove the 2 screws.

  1. Using a clip remover, remove the clip.

  1. Detach the 9 clips and remove the trim cover. Then disconnect the connector.



    B165654E01
  1. Disconnect the 2 cables from the inside handle.

  1. Remove the inside handle.



7. REMOVE FRONT SIDE AIRBAG SENSOR


    B166953
  1. Disconnect the connector.

  1. Remove the screw and side airbag sensor.



8. REMOVE REAR SEAT ASSEMBLY (for Rear Side)
  1. Remove the rear seat (Click here).



9. REMOVE REAR DOOR SCUFF PLATE LH (for Rear Side)


B165842
  1. Detach the 6 claws and 2 clips, and remove the scuff plate.



10. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Rear Side)


11. REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY LH (for Rear Side)


B165830
  1. Detach the 2 claws and remove the cover.



    B165831
  1. Remove the bolt and outer lap belt anchor.



    B165832
  1. Detach the 6 clips and remove the quarter trim panel lower.



12. REMOVE REAR SIDE AIRBAG SENSOR


    B166508
  1. Remove the bolt and side airbag sensor.

  1. Disconnect the connector.