RADIO RECEIVER (for Floor Shift Type) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT DOOR SCUFF PLATE LH |
for Double Cab:
Remove the front door scuff plate LH .
for Regular Cab:
Remove the front door scuff plate LH .
for CrewMax:
Remove the front door scuff plate LH .
| 3. REMOVE COWL SIDE TRIM BOARD LH |
![]() |
Remove the clip.
Detach the 2 clips and remove the cowl side trim board.
| 4. REMOVE INSTRUMENT SIDE PANEL LH |
![]() |
Using a moulding remover, detach the 7 claws and remove the side panel.
| 5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
![]() |
Remove the hood lock control lever.
Remove the 2 bolts.
Detach the 4 clips and claw.
![]() |
for Automatic Air Conditioning System:
Detach the 2 claws and remove the sensor.
Remove the finish panel and then disconnect the connectors.
| 6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
Twist the shift lever knob in the direction indicated by the arrow and remove it.
| 7. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Detach the 12 clips and remove the console panel.
| 8. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY |
Remove the clip.
Detach the 6 clips and remove the console panel.
w/Trailer Towing System:
Disconnect the connector

| 9. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY |
![]() |
Using a moulding remover, detach the 7 clips and remove the end panel.
except Regular Cab:
Disconnect the connector.
| 10. REMOVE CONSOLE BOX CARPET |
| 11. REMOVE REAR CONSOLE BOX ASSEMBLY |
![]() |
Remove the 2 screws.
Remove the 4 bolts and rear console box.
| 12. REMOVE FRONT CONSOLE BOX |
![]() |
Remove the 2 clips.
Remove the 6 screws and front console box.
| 13. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
![]() |
Disconnect the connector and clamp.
Detach the 12 clips and remove the finish panel.
| 14. REMOVE CENTER LOWER INSTRUMENT PANEL FINISH PANEL |
![]() |
Detach the 4 clips.
Remove the finish panel and then disconnect the connectors.
| 15. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY (for Manual Air Conditioning System) |
![]() |
Detach the 4 clips.
Remove the panel and then disconnect the connectors.
| 16. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY (for Automatic Air Conditioning System) |
![]() |
Detach the 4 clips.
Remove the panel and then disconnect the connectors.
| 17. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET |
![]() |
Remove the 4 bolts.
![]() |
Pull the radio receiver to detach the 3 clips on the backside of the radio receiver.
Disconnect the connectors and remove the radio receiver.
| 18. REMOVE NO. 1 RADIO BRACKET |
![]() |
Remove the 3 bolts and bracket.
| 19. REMOVE NO. 2 RADIO BRACKET |
![]() |
Remove the 3 bolts and bracket.