Home › BODY ELECTRICAL › AUDIO / VISUAL › FRONT DOOR SPEAKER (for Regular Cab)

FRONT DOOR SPEAKER (for Regular Cab) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).

NOTICE:
After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH


    B165652
  1. Detach the 3 clips and front lower door frame bracket garnish.



3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


    B165648
  1. Using a screwdriver, detach the 4 claws and remove the inside handle bezel.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE FRONT UPPER ARMREST BASE PANEL LH (w/ Power Window)


    B165649
  1. Using a screwdriver, detach the 2 clips and front upper armrest base panel.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connectors.



5. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


    B084267E03
  1. Insert a clip remover between the plate and trim.

  1. Turn the handle clockwise to remove the handle.



6. REMOVE COURTESY LIGHT ASSEMBLY (w/ Power Window)


    B165655
  1. Detach the claw and remove the courtesy light.

  1. Disconnect the connector.



7. REMOVE FRONT DOOR ARMREST COVER LH


8. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B167314E01
  1. Remove the 2 screws.

  1. Using a clip remover, remove the clip.

  1. Detach the 10 clips and remove the trim cover. Then disconnect the connector.



    B165654E01
  1. Disconnect the 2 cables from the inside handle.

  1. Remove the inside handle.



9. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


B165746
  1. Disconnect the speaker connector.

  1. Remove the 4 screws and speaker.

    NOTICE:
    Do not touch the cone part of the speaker.