Home › BODY ELECTRICAL › AUDIO / VISUAL › RADIO ANTENNA

RADIO ANTENNA > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE ANTENNA ORNAMENT


B164819
  1. Remove the antenna ornament as shown in the illustration.



3. REMOVE FENDER APRON MUDGUARD SEAL RH


  1. for Steel Type Bumper:
    Remove the fender apron mudguard seal.

    1. w/ Side Step:
      Remove the side step .

    2. w/ Front Fender Mudguard:
      Remove the fender mudguard .



    3. Remove the 18 clips and fender apron mudguard.


      B165874E02



  1. for Resin Type Bumper:
    Remove the fender apron mudguard seal.

    1. w/ Side Step:
      Remove the side step .

    2. w/ Front Fender Mudguard:
      Remove the fender mudguard .

    3. Using a screwdriver, remove the pin hold clip.



    4. Remove the 17 clips and fender apron mudguard.


      B165876E01



4. REMOVE FENDER ANTENNA ASSEMBLY


B164822
  1. Disconnect the connector.

  1. Remove the bolt and detach the 5 clamps.



    B164821
  1. Remove the bolt and antenna.