RADIO RECEIVER (for Column Shift Type) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT DOOR SCUFF PLATE LH |
for Double Cab:
Remove the front door scuff plate LH .
for Regular Cab:
Remove the front door scuff plate LH .
for CrewMax:
Remove the front door scuff plate LH .
| 3. REMOVE COWL SIDE TRIM BOARD LH |
![]() |
Remove the clip.
Detach the 2 clips and remove the cowl side trim board.
| 4. REMOVE INSTRUMENT SIDE PANEL LH |
![]() |
Using a moulding remover, detach the 7 claws and remove the side panel.
| 5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
![]() |
Remove the hood lock control lever.
Remove the 2 bolts.
Detach the 4 clips and claw.
![]() |
for Automatic Air Conditioning System:
Detach the 2 claws and remove the sensor.
Remove the finish panel and then disconnect the connectors.
| 6. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
![]() |
Disconnect the connector and clamp.
Detach the 12 clips and remove the finish panel.
| 7. REMOVE CENTER LOWER INSTRUMENT COVER |
Remove the 2 clips and cover.

| 8. REMOVE FRONT ASH RECEPTACLE BOX SUB-ASSEMBLY |
| 9. REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL |
![]() |
Remove the 2 screws.
Detach the 4 clips.
Remove the finish panel and then disconnect the connectors.
| 10. REMOVE INSTRUMENT PANEL CUP HOLDER ASSEMBLY |
![]() |
Detach the 2 claws and remove the door box.
![]() |
Remove the 4 screws.
Detach the 4 clips and remove the cup holder.
| 11. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY (for Manual Air Conditioning System) |
![]() |
Detach the 4 clips.
Remove the panel and then disconnect the connectors.
| 12. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY (for Automatic Air Conditioning System) |
![]() |
Detach the 4 clips.
Remove the panel and then disconnect the connectors.
| 13. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET |
![]() |
Remove the 4 bolts.
![]() |
Pull the radio receiver to detach the 3 clips on the backside of the radio receiver.
Disconnect the connectors and remove the radio receiver.
| 14. REMOVE NO. 1 RADIO BRACKET |
![]() |
Remove the 3 bolts and bracket.
| 15. REMOVE NO. 2 RADIO BRACKET |
![]() |
Remove the 3 bolts and bracket.