Home › BODY ELECTRICAL › AUDIO / VISUAL › FRONT DOOR SPEAKER (for Double Cab)

FRONT DOOR SPEAKER (for Double Cab) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. INSTALL FRONT NO. 3 SPEAKER ASSEMBLY (for 10 Speakers)


B165754E01
  1. Attach the 3 claws to install the speaker to the bracket.

    NOTICE:
    Do not touch the cone part of the speaker.



    B171783
  1. Install the speaker with bracket to the lower frame bracket garnish with the 3 screws.



2. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY



B166267E01

  1. Temporarily install the speaker by attaching the claws of the speaker to the door panel.

  1. Install the speaker with the 4 screws.

    NOTICE:
    Do not touch the cone part of the speaker.

    HINT:
    Install the screws in the order shown in the illustration.

  1. Connect the connector.



3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B165684E03
  1. Connect the 2 cables to the inside handle.

  1. Connect the connector.

  1. Attach the inside handle's knob to the door trim board.



    B166215E01
  1. Attach the 9 clips to install the door trim board.

  1. Install the inside handle and door trim board to the door trim panel with the screw.

  1. Install the door trim board to the door panel with the screw.

  1. Install the clip.



4. INSTALL FRONT DOOR ARMREST COVER LH


5. INSTALL COURTESY LIGHT ASSEMBLY


    B165683
  1. Attach the claw to install the courtesy light.

  1. Connect the connector.



6. INSTALL FRONT UPPER ARMREST BASE PANEL LH


    B166211E01
  1. Connect the connectors.

  1. Attach the 2 clips to install the front armrest upper base panel.



7. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


    B165648E03
  1. Attach the 4 claws to install the bezel plug.



8. INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH LH


    B168274E01
  1. Attach the 3 clips to install the front door lower frame bracket garnish.



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).