Home › BODY ELECTRICAL › AUDIO / VISUAL › FRONT DOOR SPEAKER (for Double Cab)

FRONT DOOR SPEAKER (for Double Cab) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH


    B168274E01
  1. Detach the 3 clips and remove the door lower frame bracket garnish.



3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


    B165648E02
  1. Using a screwdriver, detach the 4 claws and remove the inside handle bezel.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE FRONT UPPER ARMREST BASE PANEL LH


    B166211
  1. Using a screwdriver, detach the 2 clips and front armrest upper base panel.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connectors.



5. REMOVE FRONT DOOR ARMREST COVER LH


6. REMOVE COURTESY LIGHT ASSEMBLY


    B165655
  1. Detach the claw and remove the courtesy light from the door trim board.

  1. Disconnect the connector.



7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B166215E01
  1. Remove the 2 screws.

  1. Using a clip remover, remove the clip.

  1. Detach the 9 clips and remove the trim cover. Then disconnect the connector.



    B165654E01
  1. Disconnect the 2 cables from the inside handle.

  1. Remove the inside handle.



8. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY



B165744E02

  1. Disconnect the speaker connector.

  1. Remove the 4 screws and speaker.

    NOTICE:
    Do not touch the cone part of the speaker.



9. REMOVE FRONT NO. 3 SPEAKER ASSEMBLY (for 10 Speakers)


B171783
  1. Remove the 3 screws and speaker with bracket.



    B165754E01
  1. Detach the 3 claws and remove the speaker from the bracket.

    NOTICE:
    Do not touch the cone part of the speaker.