FRONT POWER SEAT LUMBAR SWITCH (for Manual Seat) > REMOVAL |
| 1. REMOVE FRONT SEAT ASSEMBLY LH |
Remove the front seat (Click here).
| 2. REMOVE VERTICAL ADJUSTING HANDLE LH (for 8 Way Seat) |
![]() |
Using a screwdriver, detach the 2 claws and remove the vertical adjuster handle cap.
![]() |
Remove the 2 screws and vertical adjuster handle.
| 3. REMOVE VERTICAL SEAT ADJUSTER KNOB LH (for 8 Way Seat) |
![]() |
Remove the snap ring and vertical seat adjuster knob.
| 4. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH |
![]() |
Lift the reclining adjuster release handle.
Using a screwdriver, detach the claw and remove the reclining adjuster release handle.
| 5. REMOVE FRONT SEAT CUSHION SHIELD LH |
![]() |
Remove the hog rings and rubber bands of the seatback cover from the seat frame.
![]() |
Remove the 2 screws.
Detach the 3 claws in the order shown in the illustration, and then remove the cushion shield.
w/ Lumbar Support Adjuster:
Disconnect the switch connector.
| 6. REMOVE FRONT POWER SEAT LUMBAR SWITCH LH |
Remove the 2 screws and switch.