CENTER AIRBAG SENSOR ASSEMBLY (for Column Shift Type) > INSTALLATION |
| 1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY |
![]() |
Check that the ignition switch is OFF.
Check that the cable is disconnected from the battery negative (-) terminal.
Install the airbag sensor with the 3 bolts.
Check that there is no looseness in the installation parts of the center airbag sensor.
Connect the holder (with connectors).
Check that the waterproof sheet is properly set.
| 2. INSTALL CENTER LOWER INSTRUMENT COVER |
Install the cover with the 2 clips.

| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 4. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).