Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CENTER AIRBAG SENSOR ASSEMBLY (for Column Shift Type)

CENTER AIRBAG SENSOR ASSEMBLY (for Column Shift Type) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
  1. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE CENTER LOWER INSTRUMENT COVER


  1. Remove the 2 clips and cover.


    B171284E01



3. REMOVE CENTER AIRBAG SENSOR ASSEMBLY


    B166503
  1. Disconnect the holder (with connectors).

  1. Remove the 3 bolts and airbag sensor.