DTC U0100 Lost Communication with ECM / PCM "A" |
| DTC Code | DTC Detection Condition | Trouble Area |
| U0100 | No communication with ECM continues | ECM |
| Related DTCs | U0100: Verify communication |
| Required sensors/Components | ECM |
| Frequency of operation | Continuous |
| Duration | 1.25 seconds |
| MIL operation | Immediately |
| Sequence of operation | None |
| The monitor will run whenever the following DTCs are not present | None |
| Battery voltage | 10.5 V or more |
| Communication signal | Lost communication with ECM |
| 1.CHECK DTC OUTPUT (IN ADDITION TO DTC P0100) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / ECT / Trouble Codes.
Read the DTCs using the Techstream.
| Result | Proceed to |
| Only U0100 is output | A |
| U0100 and other DTCs are output | B |
|
| ||||
| A | |
| 2.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 3.CHECK IF DTC RECURS |
Clear the DTC (Click here).
Start the engine.
Read the DTCs using the Techstream.
| Result | Proceed to |
| No DTC | A |
| Other DTCs | B |
|
| ||||
| A | ||
| ||