Home › ENGINE ยท 1GR-FE › EMISSION CONTROL › AIR INJECTION DRIVER

AIR INJECTION DRIVER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE AIR INJECTION CONTROL DRIVER ASSEMBLY


    A153551
  1. Disconnect the 4 air injection control driver connectors.



    A153552
  1. Remove the bolt.

  1. Disconnect the 2 wire harness clamps.



    A153553
  1. Remove the 3 bolts and air injection control driver assembly.