MULTIPLEX TILT AND TELESCOPIC ECU (for Power Tilt and Power Telescopic Steering Column) > INSTALLATION |
| 1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU |
![]() |
Install the ECU with the 2 screws.
Connect the 2 ECU connectors.
| 2. INSTALL NO. 1 AIR DUCT SUB-ASSEMBLY |
![]() |
Remove the bolt and air duct.
| 3. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD INSERT |
![]() |
Remove the 4 bolts.
Detach the 2 claws.
Remove the safety pad and then disconnect the connector.
| 4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
![]() |
Remove the hood lock control lever.
Remove the 2 bolts.
Detach the 4 clips and claw.
![]() |
for Automatic Air Conditioning System:
Detach the 2 claws and remove the sensor.
Remove the finish panel and then disconnect the connectors.
| 5. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
![]() |
Connect the hood lock control cable to the hood lock lever.
Attach the 2 claws to install the hood lock lever
| 6. INSTALL LOWER STEERING COLUMN COVER |
![]() |
Attach the 2 claws to install the steering column lower cover.
| 7. INSTALL UPPER STEERING COLUMN COVER |
![]() |
Attach the claw to install the upper steering column cover.
Attach the 4 clips to install the upper steering cover onto the instrument panel cluster finish panel.
![]() |
Install the 2 screws.
| 8. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).
| 9. CONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Perform initialization (Click here).