Home › BODY › SEAT › LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Power Seat)

LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Power Seat) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT SEAT ASSEMBLY LH
  1. Remove the front seat (Click here).



2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB LH


B166941E01
  1. Apply protective tape around the cushion shield.

  1. Using a screwdriver, detach the 2 claws and remove the knob.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE RECLINING POWER SEAT SWITCH KNOB LH


B166942E01
  1. Using a screwdriver, detach the 2 claws and remove the knob.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE FRONT SEAT CUSHION SHIELD LH


    B166944E01
  1. Remove the hog rings and rubber bands of the seatback cover from the seat frame.

  1. Remove the 2 screws.



    B166945
  1. Remove the 3 screws.

  1. Detach the 2 claws and remove the cushion shield.

  1. Disconnect the switch connectors.



5. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
  1. Driver Side:
    Disconnect the 2 connectors and detach the 4 clamps.

  1. Passenger Side:
    Disconnect the connector and detach the clamp.



    B166598
  1. Remove the nut and front seat inner belt.



6. REMOVE INNER FRONT SEAT CUSHION SHIELD LH


B166948
  1. Remove the screw.

  1. Detach the 2 claws and clip, and then remove the cushion shield.



7. REMOVE FRONT SEATBACK COVER WITH PAD LH


B167194
  1. Disconnect the seat heater connector.

  1. Detach the wire harness clamp.



    B167101E03
  1. Detach the hook.



    B167102E01
  1. Remove the hog rings and seatback cover wires.



    B165533
  1. Remove the nut and seatback cover bracket from the seat frame.



    B165529
  1. Detach the 4 claws and remove the 2 headrest supports.



    B165534E03
  1. Remove the hog rings and seatback cover with pad.



8. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH


    B167105E01
  1. Remove the 2 springs.

  1. Detach the 6 hooks and remove the seatback spring.



    B167109
  1. Disconnect the lumbar support adjuster connector.

  1. Remove the 2 screws and lumbar support adjuster.



    B167110
  1. Detach the 3 claws and remove the bush from the seat frame.