Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW REGULATOR MOTOR (for Rear Door)

POWER WINDOW REGULATOR MOTOR (for Rear Door) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
  1. for Double Cab:
    Remove the rear door inside handle bezel plug LH .

  1. for CrewMax:
    Remove the rear door inside handle bezel plug LH .



3. REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH
  1. for Double Cab:
    Remove the rear upper door armrest base panel LH .

  1. for CrewMax:
    Remove the rear upper door armrest base panel LH .



4. REMOVE REAR DOOR FRAME GARNISH LH
  1. for Double Cab:
    Remove the rear door frame garnish LH .

  1. for CrewMax:
    Remove the rear door frame garnish LH .



5. REMOVE COURTESY LIGHT ASSEMBLY
  1. for Double Cab:
    Remove the courtesy light assembly .

  1. for CrewMax:
    Remove the courtesy light assembly .



6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
  1. for Double Cab:
    Remove the rear door trim board sub-assembly LH .

  1. for CrewMax:
    Remove the rear door trim board sub-assembly LH .



7. REMOVE REAR NO. 2 DOOR TRIM BRACKET
  1. for Double Cab:
    Remove the rear No. 2 door trim bracket .

  1. for CrewMax:
    Remove the rear No. 2 door trim bracket .



8. REMOVE REAR DOOR SERVICE HOLE COVER LH
  1. for Double Cab:
    Remove the rear door service hole cover LH .

  1. for CrewMax:
    Remove the rear door service hole cover LH .



9. REMOVE REAR DOOR GLASS RUN LH
  1. for Double Cab:
    Remove the rear door glass run LH .

  1. for CrewMax:
    Remove the rear door glass run LH .



10. REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH
  1. for Double Cab:
    Remove the rear door rear lower window frame sub-assembly LH .

  1. for CrewMax:
    Remove the rear door rear lower window frame sub-assembly LH .



11. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
  1. for Double Cab:
    Remove the rear door glass sub-assembly LH .

  1. for CrewMax:
    Remove the rear door glass sub-assembly LH .



12. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
  1. for Double Cab:
    Remove the rear door window regulator sub-assembly LH .

  1. for CrewMax:
    Remove the rear door window regulator sub-assembly LH .



13. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH


B165662
  1. Using a T25 "TORX" driver, remove the 3 screws and motor.

    NOTICE:
    Be careful when removing the screws as the motor may fall and become damaged.