Home › ENGINE ยท 3UR-FBE › LUBRICATION › ENGINE OIL COOLER

ENGINE OIL COOLER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. DRAIN ENGINE OIL
  1. Remove the oil filler cap.

  1. Remove the oil pan drain plug and gasket, and drain the engine oil into a container.

  1. Install a new gasket and the oil pan drain plug.

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }



3. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap. Then drain the coolant from the radiator.

  1. Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.



  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



    A191562E01

  1. Tighten the radiator drain cock plug by hand.



4. REMOVE FAN AND GENERATOR V BELT
  1. Remove the fan and generator V belt (Click here)



5. REMOVE OIL FILTER ELEMENT
  1. Remove the oil filter element (Click here).



6. REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY


    A163657
  1. Disconnect the sender gauge connector.



    A162467
  1. Remove the oil pressure sender gauge.



7. DISCONNECT COOLER COMPRESSOR ASSEMBLY


    A163332
  1. Remove the 2 bolts, 2 nuts and 2 stud bolts, and disconnect the cooler compressor.

    HINT:
    It is not necessary to completely remove the compressor. With the hoses connected to the compressor, hang the compressor on the vehicle body with a rope.



8. REMOVE NO. 2 WATER BY-PASS PIPE


    A162468
  1. Remove the 3 bolts.

  1. Remove the 4 hoses and water by-pass pipe.



9. REMOVE NO. 1 OIL COOLER BRACKET


    A163672
  1. Remove the 2 nuts and bracket.

  1. Disconnect the ground wire from the cylinder block.



10. REMOVE OIL FILTER BRACKET


    A162469
  1. Remove the 2 bolts, 2 nuts and filter bracket.



    A162470
  1. Remove the 2 O-rings.



11. REMOVE OIL COOLER ASSEMBLY


    A162471
  1. Remove the 5 nuts and oil cooler from the oil filter bracket.



    A162475
  1. Remove the 2 O-rings.



12. REMOVE OIL COOLER SPACER


    A162472
  1. Remove the bolt and oil cooler spacer from the oil filter bracket.



    A162474E01
  1. Remove the gasket.