Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P0606    ECM / PCM Processor

for Preparation Click here


DESCRIPTION

The ECM continuously monitors its main and sub CPUs. This self-check ensures that the ECM is functioning properly. If outputs from the CPUs are different and deviate from the standard, the ECM will illuminate the MIL and set a DTC immediately.

DTC Code
DTC Detection Condition
Trouble Area
P0606
When either condition below are met
  1. ECM main CPU error
  2. ECM sub CPU error
ECM

MONITOR STRATEGY


Related DTC
P0606: ECM range check
Required sensors/Components (Main)
ECM
Required sensors/Components (Related)
-
Frequency of Operation
Continuous
Duration
16 seconds
MIL Operation
Immediate
Sequence of Operation
None

TYPICAL ENABLING CONDITIONS


Monitor runs whenever the following DTCs are not present
None

TYPICAL MALFUNCTION THRESHOLDS


Either A or B condition is met
-
A. DMA communication
No response
B. Watchdog from Monitoring Processor
Not toggle

INSPECTION PROCEDURE

HINT:
Read freeze frame data using the Techstream. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

1.CHECK DTC
  1. Clear DTC (Click here).

  1. Turn the ignition switch OFF.

  1. Disconnect the cable from the negative battery terminal and wait for 1 minute.

  1. Connect the cable to the negative battery terminal.

  1. Turn the ignition switch ON.

  1. Check DTC.

    OK:
    P0606 is not present.



NG
REPLACE ECM (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)