DTC P1607 Cruise Control Input Processor |
| Related DTC | P1607: Internal control module range check |
| Required sensors/Components (Main) | ECM |
| Required sensors /Components (Related) | Cruise control |
| Frequency of Operation | Continuous |
| Duration | 0.3 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever the following DTCs are not present | None |
| DMA communication error | Not detected |
| Cruise control | Forbiddance |
| When either condition below is met: | - |
| Operating |
| Operating |
| 1.CHECK DTC |
Clear DTC (Click here).
Turn the ignition switch OFF.
Disconnect the cable from the negative battery terminal and wait for 1 minute.
Connect the cable to the negative battery terminal.
Turn the ignition switch ON.
Check DTC.
|
| ||||
| OK | ||
| ||