Home › BODY ELECTRICAL › AUDIO / VISUAL › REAR DOOR SPEAKER (for CrewMax)

REAR DOOR SPEAKER (for CrewMax) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE REAR DOOR FRAME GARNISH LH


    B169253
  1. Detach the 5 clips and remove the rear door frame garnish.



3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH


    B166242
  1. Using a screwdriver, detach the 4 claws and remove the inside handle bezel.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH


    B166243
  1. Using a screwdriver, detach the 2 clips and rear upper door armrest base panel. Then disconnect the connector.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE COURTESY LIGHT ASSEMBLY


    B165655
  1. Detach the claw and remove the courtesy light from the door trim board.

  1. Disconnect the connector.



6. REMOVE REAR DOOR ARMREST COVER LH


7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    B169254E01
  1. Remove the 2 screws.

  1. Using a clip remover, remove the clip.

  1. for Standard:

    1. Detach the 10 clips and remove the trim board.

  1. for 12 Speakers:

    1. Detach the 10 clips and remove the trim board. Then disconnect the connector.



    B165654E01
  1. Disconnect the 2 cables from the inside handle.

  1. Remove the inside handle.



8. REMOVE REAR NO. 1 SPEAKER ASSEMBLY



B165745E02

  1. Disconnect the speaker connector.

  1. Remove the 3 screws and speaker.

    NOTICE:
    Do not touch the cone part of the speaker.



9. REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 12 Speakers)


B169722
  1. Detach the 3 claws and remove the speaker.