REAR DOOR LOCK (for CrewMax) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH |
![]() |
Using a screwdriver, detach the 4 claws and remove the inside handle bezel.
| 3. REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH |
![]() |
Using a screwdriver, detach the 2 clips and rear upper door armrest base panel. Then disconnect the connector.
| 4. REMOVE REAR DOOR FRAME GARNISH LH |
![]() |
Detach the 5 clips and remove the rear door frame garnish.
| 5. REMOVE COURTESY LIGHT ASSEMBLY |
![]() |
Detach the claw and remove the courtesy light from the door trim board.
Disconnect the connector.
| 6. REMOVE REAR DOOR ARMREST COVER LH |
| 7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH |
![]() |
Remove the 2 screws.
Using a clip remover, remove the clip.
for Standard:
Detach the 10 clips and remove the trim board.
for 12 Speakers:
Detach the 10 clips and remove the trim board. Then disconnect the connector.
![]() |
Disconnect the 2 cables from the inside handle.
Remove the inside handle.
| 8. REMOVE REAR NO. 2 DOOR TRIM BRACKET |
![]() |
Remove the 2 screws and bracket.
| 9. REMOVE REAR DOOR SERVICE HOLE COVER LH |
![]() |
Disconnect the connector and 5 clamps.
Remove the rear door service hole cover.
| 10. REMOVE REAR DOOR GLASS RUN LH |
![]() |
Remove the rear door glass run.
| 11. REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH |
![]() |
Remove the 2 bolts and rear door rear lower window frame.
| 12. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH |
![]() |
Temporarily install the power window regulator switch.
Move the door glass until the bolts appear in the service holes.
Remove the 2 bolts.
Remove the rear door glass from the rear door window regulator as shown in the illustration.
Remove the power window regulator switch.
| 13. REMOVE REAR DOOR LOCK ASSEMBLY LH |
![]() |
Disconnect the connector.
Using a T30 "TORX" wrench, remove the 3 screws and door lock.
| 14. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH |
![]() |
Using a screwdriver, detach the claw.
![]() |
Remove the rear door lock remote control cable.
| 15. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH |
![]() |
Using a screwdriver, detach the 3 claws.
![]() |
Remove the rear door inside locking cable.