Home › BODY ELECTRICAL › AUDIO / VISUAL › REAR SEAT ENTERTAINMENT SYSTEM

REAR SEAT ENTERTAINMENT SYSTEM > Sound Signal Circuit between Radio Receiver and Television Display Assembly

for Preparation Click here


DESCRIPTION

This circuit sends a sound signal from the television display to the radio receiver.

WIRING DIAGRAM


E145840E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY - RADIO RECEIVER)


    E145843E01
  1. Disconnect the W2 display connector.

  1. Disconnect the K22 receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    W2-28 (R+) - K22-2 (CDR+)
    Always
    Below 1 Ω
    W2-29 (R-) - K22-3 (CDR-)
    W2-30 (L+) - K22-4 (CDL+)
    W2-31 (L-) - K22-5 (CDL-)
    W2-27 (SLD9) - K22-1 (CSLD)
    W2-28 (R+) - Body ground
    Always
    10 KΩ or higher
    W2-29 (R-) - Body ground
    W2-30 (L+) - Body ground
    W2-31 (L-) - Body ground
    W2-27 (SLD9) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK TELEVISION DISPLAY


    E145844E01
  1. Reconnect the W2 display connector.

  1. Using an oscilloscope, check the waveform between each terminal and the body ground according to the conditions, as shown in the table below.

    Waveform:
    Tester Connection
    Condition
    Specified Condition
    W2-28 (R+) - Body ground
    Audio sound is being produced
    A waveform synchronized with sound is output
    W2-29 (R-) - Body ground
    W2-30 (L+) - Body ground
    W2-31 (L-) - Body ground



NG
REPLACE TELEVISION DISPLAY (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)