Home › BODY ELECTRICAL › AUDIO / VISUAL › TELEVISION DISPLAY

TELEVISION DISPLAY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE ROOM NO. 1 LIGHT ASSEMBLY


B169721
  1. Detach the 4 clips and remove the light.



3. REMOVE TELEVISION DISPLAY ASSEMBLY


B169720
  1. Disconnect the connector.

  1. Remove the 4 bolts.

  1. Detach the 2 clips and 2 claws, and remove the television display.



4. REMOVE ROOF HEADLINING ASSEMBLY (for CrewMax)
  1. Remove the roof headlining (Click here).



5. REMOVE TELEVISION DISPLAY BRACKET


B169719E03
  1. Remove the 4 bolts.

  1. Detach the clip and 2 claws, and remove the bracket.