Home › BODY ELECTRICAL › AUDIO / VISUAL › REAR SEAT ENTERTAINMENT SYSTEM

REAR SEAT ENTERTAINMENT SYSTEM > Mute Signal Circuit between Radio Receiver and Television Display Assembly

for Preparation Click here


DESCRIPTION

The radio receiver controls the volume according to the mute signal from the television display.

WIRING DIAGRAM


E145845E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY - NAVIGATION RECEIVER)


    E145843E03
  1. Disconnect the W2 display connector.

  1. Disconnect the K22 receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    W2-26 (MUTE) - K22-6 (MUTE)
    Always
    Below 1 Ω
    W2-26 (MUTE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK TELEVISION DISPLAY


    E145846E01
  1. Reconnect the W2 display connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    W2-26 (MUTE) - Body ground
    Ignition switch ACC, television display is playing → Changing modes
    3.5 V or higher → Below 1 V



NG
REPLACE TELEVISION DISPLAY (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)