REAR SEAT ENTERTAINMENT SYSTEM > Sound Signal Circuit between Navigation Receiver Assembly and Television Display Assembly |

| 1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY - NAVIGATION RECEIVER) |
![]() |
Disconnect the W2 display connector.
Disconnect the K8 receiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K8-2 (CDR+) - W2-28 (R+) | Always | Below 1 Ω |
| K8-3 (CDR-) - W2-29 (R-) | ||
| K8-4 (CDL+) - W2-30 (L+) | ||
| K8-5 (CDL-) W2-31 (L-) | ||
| K8-1 (CSLD) - W2-27 (SLD9) | ||
| K8-2 (CDR+) - Body ground | Always | 10 kΩ or higher |
| K8-3 (CDR-) - Body ground | ||
| K8-4 (CDL+) - Body ground | ||
| K8-5 (CDL-) Body ground | ||
| K8-1 (CSLD) - Body ground |
|
| ||||
| OK | |
| 2.CHECK TELEVISION DISPLAY |
![]() |
Reconnect the W2 display connector.
Using an oscilloscope, check the waveform between each terminal and the body ground according to the conditions, as shown in the table below.
| Tester Connection | Condition | Specified Condition |
| W2-28 (R+) - Body ground | Audio sound is being produced | A waveform synchronized with sound is output |
| W2-29 (R-) - Body ground | ||
| W2-30 (L+) - Body ground | ||
| W2-31 (L-) - Body ground |
|
| ||||
| OK | ||
| ||