Home › BODY ELECTRICAL › AUDIO / VISUAL › REAR SEAT ENTERTAINMENT SYSTEM

REAR SEAT ENTERTAINMENT SYSTEM > Display Signal Circuit between Television Display Assembly and Navigation Receiver Assembly

for Preparation Click here


DESCRIPTION

This circuit sends a display signal from the television display to the navigation receiver.

WIRING DIAGRAM


E145839E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY - NAVIGATION RECEIVER)


    E145841E01
  1. Disconnect the W2 display connector.

  1. Disconnect the K5 receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    W2-11 (NTSO) - K5-1 (VV+)
    Always
    Below 1 Ω
    W2-10 (SGN1) - K5-4 (VV-)
    W2-9 (SLD) - K5-4 (VV-)
    W2-11 (NTSO) - Body ground
    Always
    10 kΩ or higher
    W2-10 (SGN1) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK TELEVISION DISPLAY (NTSO SIGNAL)


    E145842E01
  1. Reconnect the W2 display connector.

  1. Check that waveform of the display using an oscilloscope.

    OK:
    Waveform is as shown in the illustration.

    Item
    Content
    Terminal No. (Symbols)
    W2-11 (NTSO) - Body ground
    Tool Setting
    200 mV/DIV., 10 μs/DIV.
    Condition
    DVD displayed on television display



NG
REPLACE TELEVISION DISPLAY (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)