Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG CUT-OFF SWITCH

AIRBAG CUT-OFF SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL AIRBAG CUT-OFF SWITCH
  1. Attach the 2 claws to install the switch.



2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    B160593
  1. Attach the 3 claws to install the finish panel.

  1. Install the 3 screws.

  1. Install the bolt.



3. INSTALL INSTRUMENT SIDE PANEL RH


    B163940
  1. Attach the 6 claws to install the side panel.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



6. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here)