Home › ENGINE ยท 3UR-FBE › ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
*: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.CONNECT TECHSTREAM TO DLC3*

        HINT:
        If the display indicates a communication fault in the Techstream, inspect the DLC3.
        When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.


      NEXT


      4.CHECK DTC AND FREEZE FRAME DATA*
      1. Check for DTCs (Click here) and freeze frame data (Click here).

        HINT:
        Record or print DTCs and freeze frame data, if necessary.


      NEXT


      5.CLEAR DTC AND FREEZE FRAME DATA*
      1. Clear DTCs and freeze frame data (Click here).


      NEXT


      6.CONDUCT VISUAL INSPECTION

        NEXT


        7.SET CHECK MODE DIAGNOSIS*
        1. Switch the ECM from normal mode to check mode.

          HINT:
          Refer to Check Mode Procedure (Click here).


        NEXT


        8.CONFIRM PROBLEM SYMPTOMS
        1. Refer to Problem Symptoms Table (Click here).

          HINT:
          If the engine does not start, perform steps 10 and 12 first.

        2. Result 
          Result
          Proceed to
          Malfunction does not occur
          A
          Malfunction occurs
          B


        B.
        GO TO STEP 10
        A


        9.SIMULATE SYMPTOMS

          HINT:
          Refer to Symptom Simulation (Click here).


        NEXT


        10.CHECK DTC*
        1. Check for DTCs.

          HINT:
          Refer to DTC Check / Clear (Click here).

        2. Result 
          Result
          Proceed to
          Malfunction code
          A
          No code
          B


        B.
        GO TO STEP 12
        A


        11.REFER TO DTC CHART
        1. Refer to Diagnostic Trouble Code Chart (Click here).


        NEXT

        GO TO STEP 14


        12.CONDUCT BASIC INSPECTION
        1. Conduct basic inspection (Click here).

        2. Result 
          Result
          Proceed to
          Malfunctioning parts not confirmed
          A
          Malfunctioning parts confirmed
          B


        B.
        GO TO STEP 17
        A


        13.REFER TO PROBLEM SYMPTOMS TABLE
        1. Refer to Problem Symptoms Table (Click here).

        2. Result 
          Result
          Proceed to
          Malfunctioning circuit confirmed
          A
          Malfunctioning parts confirmed
          B


        B.
        GO TO STEP 17
        A


        14.CHECK ECM POWER SOURCE CIRCUIT
        1. Check the ECM power source circuit.

          HINT:
          Refer to ECM Power Source Circuit (Click here).


        NEXT


        15.CONDUCT CIRCUIT INSPECTION
          Result 
          Result
          Proceed to
          Malfunction not confirmed
          A
          Malfunction confirmed
          B


        B.
        GO TO STEP 18
        A


        16.CHECK FOR INTERMITTENT PROBLEMS
        1. Check for intermittent problems.

          HINT:
          Refer to Check for Intermittent Problems (Click here).


        NEXT

        GO TO STEP 18


        17.CONDUCT PARTS INSPECTION

          NEXT


          18.IDENTIFY PROBLEM

            NEXT


            19.ADJUST AND/OR REPAIR

              NEXT


              20.CONDUCT CONFIRMATION TEST

                NEXT

                END