Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for DVD)

NAVIGATION SYSTEM (for DVD) > Voice is not Recognized

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK NAVIGATION SETTING


    E176552
  1. Enter the "Setup" screen by pressing the "Setup" switch.

  1. Select "Voice".



    E176556
  1. Check that "Voice Recognition Guidance" is not "Off".

    OK:
    "Voice Recognition Guidance" is not off.



NG
TURN "Voice Recognition Guidance" ON
OK


2.CHECK MAP DISC


    I100152E12
  1. Check that the map disc is not deformed or cracked.

    OK:
    No deformations or cracks on the map disc



NG
REPLACE MAP DISC
OK


3.CHECK MAP DISC


    I100201E04
  1. Check for dirt on the map disc surface.

    OK:
    No dirt is on the map disc surface.

    HINT:
    If the disc is dirty, clean the disc by wiping the disc surface radially with a soft cloth.

    NOTICE:
    Do not use a conventional record cleaner or antistatic preservative.



NG
CLEAN MAP DISC
OK


4.CHECK MICROPHONE


    E176524E01
  1. Enter the "Function Check/Setting" mode and select "Mic & Voice Recognition" (Click here).

  1. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

  1. Push the recording switch and perform voice recording.

    HINT:
    Voice can be recorded up to 5 seconds.

  1. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

    OK:
    All check results are normal.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)