Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here


HINT:
Perform "Inspection After Repairs" after replacing the engine coolant temperature sensor (Click here).



1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
  1. Install a new gasket to the sensor.

  1. Using a 19 mm deep socket wrench, install the sensor.

    Torque:
    20 N*m{ 200 kgf*cm , 14 ft.*lbf }

    HINT:
    Perform "Inspection After Repairs" after replacing the engine coolant temperature sensor (Click here).

  1. Connect the sensor connector.



2. INSTALL INTAKE MANIFOLD
(Click here)