Home › ENGINE ยท 1GR-FE › COOLING › WATER PUMP

WATER PUMP > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FOR COOLANT LEAK

HINT:
Perform this inspection when the engine is cold.

  1. Visually inspect the engine compartment for the following conditions:

    1. There is a large amount of coolant in the engine compartment or on the underside of the hood near the fan and generator V belt.

    2. Liquid coolant is dripping from around the water pump.

    3. The coolant level in the reservoir is below the L line and there are traces of leakage around the water pump.
      If any of the above conditions exist, replace the water pump assembly.



  1. Inspect the area around the water pump.

    HINT:
    Check for deposits around the drain plug of the water pump.


    1. Remove the fan shroud (Click here).



    2. A226460E01
    3. Press a piece of paper towel against the drain plug or deposits on the lip of the drain plug and check that the paper towel is not wet.
      Text in Illustration 
      *1
      Drain Plug
      If the paper towel is wet, replace the water pump assembly.
      If the paper towel is not wet, thoroughly clean the area around the water pump.



2. INSPECT WATER PUMP ASSEMBLY


    A226461
  1. Turn the pulley and check that the water pump bearing moves smoothly and quietly.
    If necessary, replace the water pump assembly.

  1. Turn the pulley and check that the water pump bearing moves smoothly and quietly.
    If necessary, replace the water pump assembly.



3. INSPECT FLUID COUPLING ASSEMBLY


    A237563
  1. Remove the 4 nuts and fan from the fluid coupling.



    A224914
  1. Check the turning smoothness of the fluid coupling.
    If necessary, replace the fluid coupling assembly.



    A237564
  1. Check the fluid coupling for damage or silicon oil leaks.
    If necessary, replace the fluid coupling assembly.

  1. Install the fan with the 4 nuts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Install the fan shroud (Click here).