VEHICLE STABILITY CONTROL SYSTEM > TC and CG Terminal Circuit |

| 1.INSPECT DLC3 (TC AND CG TERMINAL) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| J17-13 (TC) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J17-4 (CG) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (DLC3 - ECM) |

Disconnect the A24 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J17-13 (TC) - A24-16 (TC) | Always | Below 1 Ω |
| J17-13 (TC) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J17-4 (CG) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.CHECK ECM (DLC3 INPUT) |
![]() |
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
Check if the ABS warning light is blinking.
| Result | Proceed to |
| ABS warning light is blinking | A |
| ABS warning light is not blinking (for 1GR-FE) | B |
| ABS warning light is not blinking (for 1UR-FE) | C |
| ABS warning light is not blinking (for 3UR-FE) | D |
| ABS warning light is not blinking (for 3UR-FBE) | E |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| A | ||
| ||