TIRE PRESSURE WARNING SYSTEM > PRECAUTION |
| 1.TIRE PRESSURE WARNING SYSTEM PRECAUTION |
![]() |
When the tire pressure warning light turns on, immediately check the tire pressures and adjust them to the specified value(s).
| Tire Size | Front Pressure | Rear Pressure |
| P255/70R18 | 210 kPa (2.1 kgf/cm2, 30 psi) | 230 kPa (2.3 kgf/cm2, 33 psi) |
| P275/65R18 | 210 kPa (2.1 kgf/cm2, 30 psi) | 230 kPa (2.3 kgf/cm2, 33 psi) |
| P275/55R20 | 210 kPa (2.1 kgf/cm2, 30 psi) | 230 kPa (2.3 kgf/cm2, 33 psi) |
When the tire pressure warning light turns on after blinking for 1 minute, there is a malfunction in the system. Check for DTCs.
It is necessary to register the transmitter ID in the tire pressure warning ECU after replacing the tire pressure warning valve and transmitter and/or tire pressure warning ECU (Click here).
When replacing the tire pressure warning ECU:
Using the Data List, read the transmitter IDs registered in the ECU and make a note of them before removing the tire pressure warning ECU.
Register the transmitter IDs after installing a new tire pressure warning ECU.
When replacing the tire pressure warning valve and transmitter:
Take a note of the 8 digit number (transmitter ID) written on the new tire pressure warning valve and transmitter when replacing the old one. Register the transmitter ID in the tire pressure warning ECU after replacing the tire pressure warning valve and transmitter and installing the tires and wheels on the vehicle.

When replacing the tire pressure warning ECU and/or the tire pressure warning valves and transmitters, it is necessary to perform initialization (Click here) after the registration (Click here).
Precautions about the tire pressure:
| 2.IN CASE OF TIRE AND WHEEL REPLACEMENT |
Depending on the tire type, the system may not function properly even if the specified wheels are used.
When tires and wheels are replaced, always ensure that each transmitter ID is correctly registered.
| 3.INITIALIZATION PRECAUTION |
Initialize the tire pressure warning system after any of the following is performed:
| 4.FAIL-SAFE FUNCTION |
When a system malfunction occurs in the tire pressure warning system, the tire pressure warning light comes on after blinking for 1 minute and informs the driver of the system failure.
The result of this diagnosis is stored in the tire pressure warning ECU.
| 5.CHECK TIRE PRESSURE AFTER REPAIRS |
After repairs, confirm that the actual tire pressures are displayed in the Data List (Click here).