TIRE PRESSURE WARNING SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Turn the ignition switch OFF.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and the Techstream on.
Enter the following menu items: Chassis / Tire Pressure Monitor / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Mode Status | Tire pressure warning system mode/Normal or Test | Normal: Normal mode Test: Test mode | - |
| Main Tire | Number of tire IDs to be registered/ 4 or 5 | 4 should be displayed | - |
| Vehicle Speed | Vehicle speed reading/ min.: 0 km/h (0 mph), max.: 255 km/h (158 mph) | Actual vehicle speed | Speed indicated on the combination meter |
| Registered ID1 Code | Registered ID1 code/ min.: 0 max.: FFFFFFFF*1 | The transmitter ID registered in the transmitter ID1 is displayed | - |
| Registered ID2 Code | Registered ID2 code/ min.: 0 max.: FFFFFFFF*1 | The transmitter ID registered in the transmitter ID2 is displayed | - |
| Registered ID3 Code | Registered ID3 code/ min.: 0 max.: FFFFFFFF*1 | The transmitter ID registered in the transmitter ID3 is displayed | - |
| Registered ID4 Code | Registered ID4 code/ min.: 0 max.: FFFFFFFF*1 | The transmitter ID registered in the transmitter ID4 is displayed | - |
| ID Transmission Status | Transmitter ID transmission status / Finish or Now | Finish or Now | - |
| Initialization Switch | Tire pressure warning reset switch/ ON or OFF | ON: Switch is pressed and held OFF: Switch is not pressed | - |
| Initialization SW Info | Tire pressure warning reset switch setting information/ WITH or WITHOUT | WITH or WITHOUT | - |
| ID 1 Tire Inflation Pressure | ID1 tire inflation pressure / min.: Absolute pressure / 100.00 kPa (1 kgf/cm2, 14 psi), Relative pressure / 0 kPa (0 kgf/cm2, 0 psi) max.: Absolute pressure / 449.35 kPa (4.5 kgf/cm2, 63 psi), Relative pressure / 349.35 kPa (3.6 kgf/cm2, 51 psi) | Actual tire inflation pressure | If 100 kPa (1 kgf/cm2, 14 psi) for the absolute pressure or 0 kPa (0 kgf/cm2, 0 psi) is displayed for the relative pressure, the data has not been received.*2 |
| ID 2 Tire Inflation Pressure | ID2 tire inflation pressure / min.: Absolute pressure / 100.00 kPa (1 kgf/cm2, 14 psi), Relative pressure / 0 kPa (0 kgf/cm2, 0 psi) max.: Absolute pressure / 449.35 kPa (4.5 kgf/cm2, 63 psi), Relative pressure / 349.35 kPa (3.6 kgf/cm2, 51 psi) | Actual tire inflation pressure | If 100 kPa (1 kgf/cm2, 14 psi) for the absolute pressure or 0 kPa (0 kgf/cm2, 0 psi) is displayed for the relative pressure, the data has not been received.*2 |
| ID 3 Tire Inflation Pressure | ID3 tire inflation pressure / min.: Absolute pressure / 100.00 kPa (1 kgf/cm2, 14 psi), Relative pressure / 0 kPa (0 kgf/cm2, 0 psi) max.: Absolute pressure / 449.35 kPa (4.5 kgf/cm2, 63 psi), Relative pressure / 349.35 kPa (3.6 kgf/cm2, 51 psi) | Actual tire inflation pressure | If 100 kPa (1 kgf/cm2, 14 psi) for the absolute pressure or 0 kPa (0 kgf/cm2, 0 psi) is displayed for the relative pressure, the data has not been received.*2 |
| ID 4 Tire Inflation Pressure | ID4 tire inflation pressure / min.: Absolute pressure / 100.00 kPa (1 kgf/cm2, 14 psi), Relative pressure / 0 kPa (0 kgf/cm2, 0 psi) max.: Absolute pressure / 449.35 kPa (4.5 kgf/cm2, 63 psi), Relative pressure / 349.35 kPa (3.6 kgf/cm2, 51 psi) | Actual tire inflation pressure | If 100 kPa (1 kgf/cm2, 14 psi) for the absolute pressure or 0 kPa (0 kgf/cm2, 0 psi) is displayed for the relative pressure, the data has not been received.*2 |
| ID 5 Tire Inflation Pressure | - | - | - |
| ID 1 Temperature in Tire | ID1 temperature in tire/ min.: -50°C (-58°F), max.: 205°C (401°F) | Actual tire temperature | If -50°C (-58°F) is displayed, the data has not been received. |
| ID 2 Temperature in Tire | ID2 temperature in tire/ min.: -50°C (-58°F), max.: 205°C (401°F) | Actual tire temperature | If -50°C (-58°F) is displayed, the data has not been received. |
| ID 3 Temperature in Tire | ID3 temperature in tire/ min.: -50°C (-58°F), max.: 205°C (401°F) | Actual tire temperature | If -50°C (-58°F) is displayed, the data has not been received. |
| ID 4 Temperature in Tire | ID4 temperature in tire/ min.: -50°C (-58°F), max.: 205°C (401°F) | Actual tire temperature | If -50°C (-58°F) is displayed, the data has not been received. |
| ID 5 Temperature in Tire | - | - | - |
| ID 1 Battery Voltage | ID1 battery voltage/ OVER or LESS | OVER | - |
| ID 2 Battery Voltage | ID2 battery voltage/ OVER or LESS | OVER | - |
| ID 3 Battery Voltage | ID3 battery voltage/ OVER or LESS | OVER | - |
| ID 4 Battery Voltage | ID4 battery voltage/ OVER or LESS | OVER | - |
| ID 5 Battery Voltage | - | - | - |
| ID 1 Initial Threshold of Low-pressure | ID1 initial threshold of low pressure (Absolute pressure) / min.: 100.00 kPa (1 kgf/cm2, 14 psi) max.: 449.35 kPa (4.5 kgf/cm2, 63 psi) | Tire pressure after initialization | - |
| ID 2 Initial Threshold of Low-pressure | ID2 initial threshold of low pressure (Absolute pressure) / min.: 100.00 kPa (1 kgf/cm2, 14 psi) max.: 449.35 kPa (4.5 kgf/cm2, 63 psi) | Tire pressure after initialization | - |
| ID 3 Initial Threshold of Low-pressure | ID3 initial threshold of low pressure (Absolute pressure) / min.: 100.00 kPa (1 kgf/cm2, 14 psi) max.: 449.35 kPa (4.5 kgf/cm2, 63 psi) | Tire pressure after initialization | - |
| ID 4 Initial Threshold of Low-pressure | ID4 initial threshold of low pressure (Absolute pressure) / min.: 100.00 kPa (1 kgf/cm2, 14 psi) max.: 449.35 kPa (4.5 kgf/cm2, 63 psi) | Tire pressure after initialization | - |
| ID 5 Initial Threshold of Low-pressure | - | - | - |
| Number of DTC | Number of DTCs recorded/ min.: 0 max.: 255 | 0 | - |
| PERFORM ACTIVE TEST |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and the Techstream on.
Enter the following menus: Body / Combination Meter / Active Test.
According to the display on the tester, perform the "Active Test".
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. Tire Pressure Warning System | Tire pressure warning light | ON or OFF | Perform the test with the vehicle stopped and engine idling |