DTC B2611 Telescopic Position Sensor or Telescopic Motor Circuit Malfunction |

| DTC Code | Detection Condition | Trouble Area |
| B2611 | Telescopic operation stops within the operation range while operating. |
|

| 1.PERFORM ACTIVE TEST USING TECHSTREAM (TELESCO SHORT/LONG) |
![]() |
Select the Active Test, use the Techstream to generate a control command, and then check that the steering column contracts and extends.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Telesco operation | Telescopic operation | Long / Short | - |
| Result | Proceed to |
| The steering column does not contract (extend). | A |
| The steering column contracts (extends). | B |
|
| ||||
| A | |
| 2.CHECK TELESCOPIC MOTOR |
![]() |
Disconnect connector A from the multiplex tilt and telescopic ECU.
Apply 12 V battery voltage to the multiplex tilt and telescopic ECU connector. Then check the steering wheel telescopic operation.
| Measurement Condition | Specified Condition |
| 12 V battery positive (+) lead → Terminal A-2 (TEM+) 12 V battery negative (-) lead → Terminal A-6 (TEM-) | The steering column contracts. |
| 12 V battery positive (+) lead → Terminal A-6 (TEM-) 12 V battery negative (-) lead → Terminal A-2 (TEM+) | The steering column extends |
|
| ||||
| OK | ||
| ||
| 3.CHECK MULTIPLEX TILT AND TELESCOPIC ECU (VCE TERMINAL VOLTAGE) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A-3 (VCE) - A-5 (E2) | Ignition switch ON | 8 to 16 V |
|
| ||||
| OK | |
| 4.CHECK TELESCOPIC POSITION SENSOR |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A-4 (TES) - A-5 (E2) | Telescopic steering contracted or extended | Pulse generation High: 8 to 16 V Low: Below 1 V |
|
| ||||
| OK | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - TELESCOPIC POSITION SENSOR) |
![]() |
Disconnect connector A from the multiplex tilt and telescopic ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A-3 (VCE) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BODY GROUND) |
![]() |
Disconnect the J47 multiplex tilt and telescopic ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J47-11 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||