Home › STEERING › STEERING COLUMN › POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

DTC    B2624    Vehicles Speed Malfunction

for Preparation Click here


DESCRIPTION

The multiplex tilt and telescopic ECU forms a network with the ECUs of other systems through the communication bus. Each ECU informs the other ECUs that it is connected to the network by outputting a specified signal (periodic signal) to the communication bus on a regular schedule. The multiplex tilt and telescopic ECU receives vehicle speed signals from the combination meter via the communication bus to prevent improper operation of the auto away/return function during driving.

DTC Code
Detection Condition
Trouble Area
B2624
When either condition below is met:
  1. The auto away function is disabled with the last vehicle speed signal* of 10 km/h (6 mph) or more.
  2. The vehicle speed signal is lost for 5 seconds or more and the auto away/return function is disabled.
  1. CAN communication system
  2. Combination meter
  3. Multiplex tilt and telescopic ECU

HINT:
*: If the ignition switch is turned OFF immediately after the vehicle comes to a sudden stop, the last vehicle speed signal may not be 0 km/h (0 mph).


INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check the "COMMUNICATION STOP MODE TABLE" of the CAN communication system (Click here).
    Result 
    Tester Display
    Proceed to
    "Meter" is displayed.
    A
    "Meter" is not displayed.
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.READ VALUE USING TECHSTREAM (SPEED SIGNAL)
  1. Use the Data List to check if the speed signal is functioning properly.

    Tilt & Telescopic 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Freeze Speed Info
    Vehicle speed data / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)
    Actual vehicle speed
    -
    Result 
    Result
    Proceed to
    OK or NG (Tester indication is abnormal)
    A
    NG (Meter indication is abnormal)
    B

    HINT:
    A vehicle speed of 3 km/h (2 mph) or more may be displayed on the Techstream screen immediately after the vehicle comes to a sudden stop. This is caused by a delay in vehicle signal input via the communication bus and is not a malfunction.



B
CHECK COMBINATION METER SYSTEM (Click here)
A

REPLACE MULTIPLEX TILT AND TELESCOPIC ECU (Click here)