Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Stereo Component Amplifier Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the stereo component amplifier assembly.

WIRING DIAGRAM


E146482E08


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER - BATTERY AND BODY GROUND)


  1. Disconnect the K15, K16 and K17 stereo component amplifier assembly connectors.


    E191461E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K17-6 (GND) - Body ground
    Always
    Below 1 Ω
    K17-7 (GND2) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    K16-1 (+B) - K17-6 (GND)
    Always
    11 to 14 V
    K16-5 (+B2) - K17-6 (GND)
    Always
    11 to 14 V
    K15-12 (ACC) - K17-6 (GND)
    Ignition switch ACC
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)